-3%
- Description
- Size Guide
- Reviews (0)
Description
Nano-filled, light-curing protective coating for surface sealing
Advantages:-
- Glossy and aesthetic surfaces
- Easy to use
- Provides protection against discolouration
In combination with VOCO Ionofil Molar AC / Quick:-
- Protects against moisture and dehydration immediately after filling placement
- Tooth-like fluorescence
- Natural gloss
Indications:-
- Surface sealing of glass ionomer cements, provisional crowns and bridges and definitive composite restorations.
- Protecting glass ionomer cement surfaces against the effects of moisture and dehydration immediately after placement.
- Sealing glass ionomer cement liners/build-up restorations before taking impressions.
- Sealing and protecting adhesive interfaces between restoration and tooth structure.
Precaution:
- Do not use in combination with materials containing eugenol as they can impair the polymerisation or adhesion of Easy Glaze.
- Easy Glaze is volatile. Only use in well-ventilated areas. Keep bottle out of direct sunlight.
- Easy Glaze is flammable. Do not use near open flames or ignition sources.
- Easy Glaze contains multifunctional acrylates, methyl methacrylate and BHT. Easy Glaze should not be used in case of known hypersensitivities (allergies) to any of these ingredients. – In case of contact with the eyes, immediately rinse with water and seek medical advice. – In case of contact with skin or oral mucosa, immediately remove the material with a cotton pad. Thoroughly rinse affected areas with water afterwards.
Packaging
- 1 x 5ml Bottle
Direction to Use
- Ensure that the surfaces to be treated are dry.
- Dispense a few drops of Easy Glaze into a disposable dish. Replace bottle cap immediately after use.
- Apply material within 1 min. to guarantee that an oxygen inhibition layer does not form.
- Apply a thin and air bubble-free layer of the material onto the relevant surfaces with the enclosed brush.
- Light-cure all treated surfaces with a visible light (> 500 mW/cm2, halogen or LED) for 30 s immediately after application. Hold the light source as close as possible to the surfaces being polymerised. Repeat light-curing if the surfaces appear tacky or yellow.
- Repeat steps 2 – 5 if a second layer appears to be necessary.
- Where appropriate, check occlusion.
Reviews
There are no reviews yet.